HOW TO USE
1) Apply to your lenses (please note they must be completely dry)
2) Leave to dry for at least 1 minute
3) Immerse the goggles in water to spread the product
Re-apply on average every 1 to 3 sessions, depending on the speed at which fog reappears. 400 applications on average.
If your goggles fog up during the session, dip them in the water again, a protective film will reform and allow you to finish your session in good conditions.
DO NOT USE ON NEW GOGGLES, you may damage the new anti-fog treatment or scratch the lenses.
Never touch the inside of the lenses - Do not rub them.
If you rub your goggles before applying the product, the product may not work properly.
The goggles must be dry before applying the product
Replace the marker's cap after use
Do not use with contact lenses
Must not be used by kids
When used according to our recommendations for use, this product does not pose a risk to the health of users.
We have conducted tests through an independent laboratory followed by usage tests with a panel of swimmers to guarantee product compliance.
If the product gets into your eyes, rinse them with clean water for several minutes. If eye irritation persists, consult a doctor and keep the product container at hand.
CAREFULLY READ THE INSTRUCTIONS BEFORE USING THE PRODUCT
COMPOSITION OF THE LIQUID
Propylene glycol butyl ether: 1-10%
2-(2-butoxyethoxy) ethanol: 1-10%
Fluorocaliphatic oxyethylene: 1-10%
Potassium Hydroxide: 0-0.5%
Magnesium lauryl sulfate: 0 - 0,5%