- Membraned 2-layer fabric
- A strong rain corresponds to a flow of 100L/m2/h - (= rainfall of 100 mm/h)
- The rainfall simulator reproduces these conditions for 3 hours.
- Component resistant to water pressure of 5000 mm after ageing = 5000 Schmerber - average pressure of water during a downpour
- Water repellent components allows water to runs off the fabric.
- 100% taped seams.
- Central opening features a flap with a drainage channel for optimal waterproofing
RET <12: very breathable.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.
The anorak has two cuffs on each arm to limit water ingress.
They can be adjusted with a rip-tab, letting you easily put on a pair of mittens or gloves over the first cuff, then tighten the sleeve cuff above
It has three adjustment systems to ensure a good fit depending on the shape of your face but also on the desired level of protection against the rain and wind.
The visor keeps your face well protected.
The hood can be stored in the collar.
Three-way adjustable hood.
Adjustable jacket hem.
2 shoulder patches
2 hood patches
to intensify light sources.
RESISTANCE TO WEAR
Injected plastic central zip resistant to salt oxidation.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY step 1: before washing
Close all zips and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY step 2: washing
You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.
Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY step 3: drying
Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.
Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round.
HOW TO REACTIVATE THE JACKET'S WATER REPELLENCY
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a spray sold in our stores.
A score to compare the environmental impact of products
The environmental impact of the product is calculated over its entire life cycle and with different indicators. An overall score (ABCDE) is attributed to help you easily identify the products with the best environmental performance by comparing products of the same type with one another (T-shirts, trousers, backpacks, etc.). Decathlon chose to apply this voluntary environmental labelling scheme. For more information, visit: http://sustainability.decathlon.com/